The Setup file

Previous  Top  Next

Only one setup file is needed to install any Pigeon Communication System module. Simply launch the Pigeon4Setup.exe file and after you read and accepted the License Agreement, select the components from the list of available modules.



Beside each selection if the space disk required if you install the module. But because most of the modules share core components, the total will be lower than adding the disk space required by each selection. Refer to the Disk Space Required value for the exact amount required.

Press Next to access the next installation window where you will chose the destination directory:



This is where you define the main directory for the components. The core file of each component will be installed in a subdirectory:

·	The Pigeon Server will be installed in the Server subdirectory

·	The Pigeon Client will be installed in the Client subdirectory

·	The Pigeon Admin will be installed in the Admin subdirectory

·	The Pigeon Gateway will be installed in the Gateway subdirectory

·	The Pigeon Generator for Windows will be installed in your Windows\System32 directory

·	The source file for the Unix Generator will be copied in the main directory.

Continue with the installation as you normally do with any other installation.